Sorry, you need to enable JavaScript to visit this website.

Home → Forum → Zedboard Hardware Design

SPI interface design

Solved
3 posts / 0 new
Log in or register to post comments
Tue, 2017-12-26 02:38
shubham_kumar
Junior(0)
SPI interface design

I am creating a project for SPI and I have connected a zynq processor and SPI interface in standard mode. I want it to be in master mode and only one slave to be connected.
I am not understanding how to give the ext_spi_clk and where to connect it to.
I tried using other IP clock clocks but every time the bit generation is failing.
 

Top
Tue, 2017-12-26 06:52
Solution
JFoster
Moderator(69)
Hello, 

Hello, 

Perhaps try taking a look at our Tutorial 05 PL SPI Pmod reference design targeting the MiniZed located here http://zedboard.org/support/design/18891/146

Try referenceing that in getting your SPI interface working.

For educational support, please ask any remaining questions over at Digilent.
 

Thank you,

Josh

Top
Tue, 2017-12-26 21:29
(Reply to #2)
shubham_kumar
Junior(0)
Thank you very much.

Thank you very much.
 
I'll go through all of them and will come back and for now I'll mark this as solved.
And if any difficulty comes I'll get back.
 
Thanks.
:-)

Top