Sorry, you need to enable JavaScript to visit this website.

ZedBoard-HDMI Display Controller Tutorial

Unsolved
4 posts / 0 new
yangtuzi's picture
yangtuzi
Junior(0)
ZedBoard-HDMI Display Controller Tutorial

I do the lab  based on <ZedBoard HDMI Display Controller Tutorial> on my ZedBoard.
The Tutorial required software is vivado 2013.4,but my vivado is 2014.4.
When I step by step follow the Tutorial to step 20(page 22 on documentation),do Validate Design.Some warning appear:
The input pins (listed below)are either not connected or do not have a source port,and they don't have a tie-off specified.
Please check your design and connect them if needed:
/zed_hdmi_dispaly/axi_vdma_0/axi_resetn
etc..

JFoster's picture
JFoster
Moderator(48)
Hello Yang,

Hello Yang,

My suggestion would be for you to download and install the 2013.4 tool set and see if that solves your problem.

Thanks,

Josh

yangtuzi's picture
yangtuzi
Junior(0)
I have solved it.I get

I have solved it.I get Hardware_Evaluation license for v_cresample,and load the licesen.And the (1)Reset output Products;(2)Generate Output Products;(3)Reboot Vivado.Finally.generate the bit succesfully.Thankyou!

aynilian's picture
aynilian
Junior(0)
Hi Yangtuzi,

Hi Yangtuzi,
I got the hardware evaluation license for v_cresample too, but I'm using the Vivado 2016.3. I re-did the block design based on the original flow using the latest IPs. I have it compiled and can see the VDMA and the Video Stream, and the Video outputs only on the ILA, but I can't seem to see it coming out of the FPGA. Any ideas?