Sorry, you need to enable JavaScript to visit this website.

Zynq Hw training

Unsolved
2 posts / 0 new
metso
Junior(0)
Zynq Hw training

hi,

 

The 'dma_test.c' app for testing DMA transfers between different memories of Microzed works after completing the 'Developing Zynq®-7000 All Programmable SoC Hardware' training lab 6, using Vivado 2016.2. But, when running the same application after completing lab 7, the software halts when BRAM to BRAM transfer is selected. Any ideas on why this happens?

 

Best,

metso

JFoster
Moderator(66)
Hello metso,

Hello metso,

I have seen that before, it has somthing to do with adding the PWM_Int custom IP. At this timeI am not sure why that error is occuring. I will respond back when I have a solution.(it may be a while)

Regards,

Joshua