Sorry, you need to enable JavaScript to visit this website.

AMP bare metal application on Zynq ZedBoard

Unsolved
1 post / 0 new
fayyazrafiq's picture
fayyazrafiq
Junior(0)
AMP bare metal application on Zynq ZedBoard

Hi All,

I am struggling with the AMP bare metal application for ZEDBOARD. I run the application project BOOT.bin that was fine and showning the both processors are running on the target hardware. But when i create all the applications and BSPs according to the XAPP1079 with my own hardware, no UART messages. The only thing, i changed in my hardware just remove the PL interrupt and i am using UART-1 for displaying messages. I also remove the interrupt part in the code.

The linker script is the same as mentioned in the XAPP1079. I am using Xilinx 14.3 design suite.

Any help is highly appriciated.