Sorry, you need to enable JavaScript to visit this website.

Error message

The page you requested does not exist. For your convenience, a search was performed using the query file.

Page not found

Search results

  1. GPIO PL mapping

    ... you just have to reroute the signal using the constraint file. LED and button pins assignment are listed in "Zedboard HW_UG guide." ...

    Roberto - 2013-02-28 10:49 - 3 comments

  2. BSP and Xilinx SDK

    ... and find the board definition file located on that webpage that corresponds to your Vivado version. When ...

    ist_ali - 2016-12-13 08:38 - 3 comments

  3. Booting Problem

    ... Bus Width: 4-bit reading uEnv.txt ** Unable to read file uEnv.txt ** Copying Linux from SD to RAM... reading uImage 3724512 ...

    babuji - 2016-04-19 00:23 - 2 comments

  4. Keep PL configuration after PS reset

    ... to improve your load times by providing an initialization file as part of the boot.bin.  This allows various PS registers to be set to ...

    jonathanruiz - 2015-10-27 09:24 - 3 comments

  5. Program FPGA from SDK and FMC

    ... can add a description of the FMC card JTAG device (a BSDL file) so that the program driving the JTAG chain, the SDK in the case, ...

    zooker - 2015-08-03 09:43 - 4 comments

  6. Upgrading 2013.4 HDMI reference Design to 2014.4

    ... screen for this demo is located? Is it embedded in the .elf file? Top ...

    stalwar - 2015-03-11 08:25 - 4 comments

  7. use /dev/ttyACM0 in linux asUART_COM in win

    ... output in minicom maybe.But,how can I send the generated elf file to zynq board through UART and make it run? I have tried to echo XX.elf to ...

    double_crane - 2013-02-03 10:26 - 5 comments

  8. compiling new kernel from xilinx master-next

    ... exactly did you change in the ethernet mdio section of what file? Top ...

    Heinz - 2013-08-07 10:28 - 4 comments

  9. Bring up TI WILINK 8 to Zedboard

    ...       a pull-down resistor is enabled in the constraints file to achieve the logic ’0’ for this input      -Josh ...

    YevgenyKremer - 2016-07-26 07:35 - 2 comments

  10. VGA on Zedboard

    ... singal. I searched the characters "0x0000_12E1" in the TRM file, but no results returned. So these must no be any information about the ...

    parallelcell - 2012-09-10 07:42 - 8 comments

Pages